Floor drain for shower and changing areas FURO 023

Variable length (mm):

• Length (L) = 400–3000 (in increments of 100)
• Fixed width: 150 mm
   

The dimensions refer to the channel's grating dimensions.

Drains and channels always have a connection pipe and their water flow (V.g.) to consider. Water flow is always measured from the so-called bottom line of the pipe.

To facilitate product selection, we specify the total height (H) of our drains and channels. The total height is the distance from the finished floor surface to where the water exits the product. For bottom outlets, the measurement point is where the spigot begins.

The total height (H) is always made up of the top depth (D) plus the outlet section of the product. If the top depth is increased, the total height will also increase, affecting the product's water flow.

Dimensions for FURO 023:

• The top depth (D) can be selected between 56, 100 and 150 mm (56 mm is standard for lengths up to 2000 mm).
• For tile types K4 and K5, the top depth (D) varies between 36, 80, and 130 mm (36 mm is standard for lengths up to 2000 mm).
• Thus, the total height (H) of FURO 023 varies between 173, 217 and 267 mm (173 mm is standard for lengths up to 2000 mm).
• If an extension or inlet section is selected, the total height (H) increases by 60 mm.

Slope toward the outlet:

The product’s slope toward the outlet varies depending on length and chosen upper part depth. For the standard design with a centrally placed outlet, the following applies:

• For lengths up to 2000 mm with the recommended depth of 56/36 mm, the slope toward the outlet is at least 1%.
• For lengths between 2000–3000 mm and a recommended depth of 100/80 mm, the slope towards the outlet is at least 1.7%.
• For a length of 3000 mm and a depth of 56/36 mm, a slope of 0.7% towards the outlet is achieved with a centrally positioned outlet.
   

If other requirements than the above recommendations are needed, the slope will be affected.